Editing VPN Connection in Windows 10

After adding a VPN connection on your computer, you can adjust the settings with these steps:

1. Open Control Panel.

2. Click on Network & Internet.

3. Click on Network and Sharing Center.

4. Click the Change adapter settings link from the left pane.

5. Right-click the VPN adapter and select the Properties option.

   

6. In the General tab, make sure you’re using the correct domain you created while configuring DDNS — or at least you’re using the correct public IP address.

   

7. Click on the Security tab.

8. Under “Type of VPN,” select the type of VPN option.

9. Under “Data encryption,” select the Maximum strength encryption (disconnect if server declines) option.

   

10. Click the OK button.

11. Click on the Networking tab.

12. Uncheck the Internet Protocol Version 6 (TCP/IPv6) option.

13. Check the Internet Protocol Version 4 (TCP/IPv4) option.

14. Select the Internet Protocol Version 4 (TCP/IPv4) option.

15. Click the Properties button.

    

16. Click the Advanced button.

    

17. Check the Use default gateway on remote network option.

    

18. Click the OK button.

19. Click the OK button again.

20. Click the OK button once more.